Monogram Range Error Code FC

The FC error code on a Monogram range indicates that there is a problem with the door lock circuit. This circuit is responsible for preventing the oven door from opening while the oven is in use.

Symptoms of a Door Lock Circuit Malfunction

There are a few symptoms that can indicate a door lock circuit malfunction. These include:

• The oven door will not lock.
• The oven door will not unlock.
• The oven door will unlock during a cooking cycle.

Possible Causes of a Door Lock Circuit Malfunction

There are a few possible causes of a door lock circuit malfunction. These include:

• Wiring damage: The wiring that connects the control board to the door lock switches can become damaged, which can prevent the circuit from working properly.
• Switch failure: The door lock switches themselves can fail, which can also prevent the circuit from working properly.
• Control board failure: In rare cases, the control board itself can fail, which can also cause the door lock circuit to malfunction.

Troubleshooting a Door Lock Circuit Malfunction

If you suspect that the door lock circuit in your Monogram range is malfunctioning, you can try the following troubleshooting steps:

1. Check the wiring: The easiest way to check the wiring is to use a multimeter to measure the resistance between the control board and the door lock switches. If the resistance is outside of the specified range, the wiring is damaged and will need to be repaired or replaced.
2. Test the switches: The door lock switches can be tested by using a multimeter to measure the voltage between the terminals of each switch. If the voltage is not within the specified range, the switch is faulty and will need to be replaced.
3. Check the control board: If you have checked the wiring and the switches and the door lock circuit is still malfunctioning, the control board may be the problem. To check the control board, you will need to contact a qualified appliance repair technician.

Replacing the Door Lock Switches

If the door lock switches need to be replaced, you can purchase new switches from a Monogram authorized dealer. To replace the switches, follow these steps:

1. Unplug the range and remove the back panel.
2. Locate the door lock switches and remove the screws that hold them in place.
3. Remove the old switches and install the new switches.
4. Reattach the back panel and plug in the range.

Here is a more detailed explanation of each possible cause of the FC error code:

Wiring damage: The wiring that connects the control board to the door lock switches can become damaged in a number of ways. For example, the wiring can be pinched or cut during installation or maintenance, or it can be damaged by heat or moisture.

Switch failure: The door lock switches themselves are relatively simple devices, but they can fail over time. The switches can become worn out or damaged, or they can be damaged by a power surge or other electrical event.

Control board failure: In rare cases, the control board itself can fail, which can also cause the door lock circuit to malfunction. The control board is a complex electronic device, and it can be damaged by a power surge, a voltage spike, or other electrical event.

Additional Information

• The FC error code is a specific error code that is only displayed on Monogram ranges.
• If you are not comfortable troubleshooting the issue yourself, it is best to contact a qualified appliance repair technician.