Call (323) 792-1970
Customer service:    323-792-1970
  • DCS
  • DCS Refrigerator Error Code DS
Schedule Appointment
DCS Refrigerator Error Codes

DCS Refrigerator Error Code DS

The DS error code on a DCS refrigerator indicates a problem with the door switch. The door switch is a component that tells the refrigerator when the door is open or closed. If the door switch is not working properly, the refrigerator may not be able to maintain the correct temperature inside.

Symptoms of the DS Error Code

There are a few symptoms that can indicate the DS error code. These include:

  • The refrigerator door will not close properly.
  • The refrigerator will not cool properly.
  • The refrigerator may display other error codes.

Possible Causes of the DS Error Code

There are a few possible causes of the DS error code. These include:

  • A faulty door switch: The door switch itself may be faulty. This can be caused by wear and tear, or by a power surge or voltage spike.
  • A loose or damaged door switch connector: The connector that connects the door switch to the refrigerator’s control board may be loose or damaged. This can prevent the door switch from sending a signal to the control board.
  • A problem with the control board: The control board may be faulty and not receiving a signal from the door switch.

Troubleshooting the DS Error Code

If you see the DS error code on your DCS refrigerator, you can try the following troubleshooting steps:

  1. Check the door switch: Make sure that the door switch is properly seated and that the connector is not loose or damaged.
  2. Reset the refrigerator: Unplug the refrigerator for 30 seconds, then plug it back in.
  3. Contact a qualified appliance repair technician: If you have checked the door switch and the connector and the error code is still present, you may need to contact a qualified appliance repair technician.

Replacing the Door Switch

If the door switch is faulty, it will need to be replaced. You can purchase a new door switch from a DCS authorized dealer. To replace the door switch, follow these steps:

  1. Unplug the refrigerator.
  2. Remove the screws that hold the door switch in place.
  3. Remove the old door switch.
  4. Install the new door switch.
  5. Secure the new door switch with screws.
  6. Plug in the refrigerator.

The DS error code is a relatively common problem that can be caused by a variety of factors. By following the troubleshooting steps above, you can often identify and resolve the problem yourself.

Schedule Appointment