Amana Dishwasher Water Inlet Valve Problems
01 – Amana Dishwasher Water Inlet Valve
The water inlet valve opens to allow water to enter the dishwasher. If the water valve is clogged or defective, water will not flow into the dishwasher. Water inlet valves are not repairable—if the valve is defective, you must replace it.
02 – Amana Dishwasher Main Control Board
A dishwasher’s main control board provides power to nearly every electrical component in the dishwasher. A faulty board may be unable to supply power to the water inlet valve, preventing it from opening and allowing the necessary water to fill the tank.
03 – Amana Dishwasher Float Switch
The float switch is a safety designed to shut off the water inlet valve if the dishwasher is overfilling. If the float switch is defective or stuck, it might stop the dishwasher from filling correctly. You can use a multi meter to test the float switch for continuity. If the float switch is defective, replace it.
04 – Amana Dishwasher Control Board
A dishwasher’s control board provides power to nearly every electrical component in the dishwasher. A faulty board may be unable to supply power to the water inlet valve, preventing it from opening and allowing the necessary water to fill the tank.
05 – Water Supply Problem
Over time, calcium deposits can build up in the water supply valve or in the small filter screen inside the water inlet valve. If the water inlet valve is clogged with sediments, the dishwasher won’t fill properly. Before working on the water line, first shut off the water supply. Inspect the valve to determine if it is clogged. In addition, check the water pressure to the valve. The water inlet valve requires at least 20 psi to function properly.
06 – Amana Dishwasher Pressure Switch
A dishwasher pressure switch is the component that will send a signal to shut off the water inlet valve once an appropriate amount of water has entered the tank for a wash cycle. If the pressure switch is malfunctioning, it may prevent the inlet valve from opening and filling the tank. You can use a multimeter to test the pressure switch’s terminals for appropriate changes in electrical continuity before and after blowing air into the attached pressure tube. If the switch does not test appropriately, it should be replaced.